Width of the Mounting Bracket for the Brophy D-Ring Tie Down Anchor # LRB1
Question:
What is the width of the part that has the two holes. I am trying to find something that will fit within a U-post that has a 1 9/32 vertical slot and the holes on the post are 1inch apart. thank you
asked by: Ruth C
0
Expert Reply:
I went out to the warehouse and found that the width of the mounting bracket for the Brophy D-Ring Tie Down Anchor # LRB1 measured 1-3/4".
I have attached a photo with the dimensions listed for you to check out.
expert reply by:
Jon G
0
click to enlarge
Product Page this Question was Asked From
Brophy D-Ring Tie Down Anchor - Bolt-On - 2-3/8" Wide - Surface Mount - 4,000 lbs
- Tie Down Anchors
- Trailer Tie-Down Anchors
- Truck Tie-Down Anchors
- Tie-Down Cleats and Rings
- 4000 lbs
- D-Ring
- Surface Mount - Bolt-On
- Brophy
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: How To Install The Advent Air RV Air Conditioner System With ACTH12 Thermostat
- Q&A: Installation Instructions for Advent Air Rooftop RV Air Conditioner # ACM135
- Q&A: Can Curt D-Ring Tie Down Anchor Be Welded to Aluminum Trailer
- Q&A: Can I Use A 10mm Bolt Instead Of The 3/8 Bolt With The CargoBuckle Ratchet Straps IMF18800
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Q&A: Recommended Way to Install Heavy Steel D-Ring Tie Down to Aluminum Floor of Car Hauler
- Q&A: Replacement for Atwood 61101 Brake Actuator
- Q&A: Replacement for Dexter Mobile Home Axle Grease Seal 10-41
- Article: Trailer Wiring Diagrams
- Article: Determining Trailer Tongue Weight
- Article: My Trailer Hitch Doesn't Fit
- Article: Trailer Lighting Requirements
- Article: Which Sway Control Hitch is Right For Your Trailer?
- Article: Types of Trailer Hitches: How and Why to Use Each