Is Using a Steel Crossmember Required When Installing Timbren Silent Ride Suspension Kit
Question:
Listing reads that in order to install this system a 2x2 steel crossmember must be utilized. I can see where the crossmember installs on other Timbren systems, but where would it install on this system?
asked by: Bruce H
0
Expert Reply:
I attached a picture that I took from the instructions that shows where the 2x2 crossmember attaches on the Timbren Silent Ride Suspension for Single Axle Trailers # TSR3500S05.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
Timbren Silent Ride Suspension for Single Axle Trailers w/ 2" Square Axles - 3,500 lbs
- Trailer Suspension Parts
- Leaf Spring Replacement System
- Camper
- Car Hauler
- Utility Trailer
- 3500 lbs
- Square Axle - 2 Inch
- Single Axle
- Timbren
more information >
Continue Researching
- Q&A: Reese Goose Box Recommendation to Replace MORryde Pin Box SPB72-1621LD
- Q&A: Recommended Wedge for a Turning Point Pin Box and a Curt Crosswing 5th Wheel Hitch
- Q&A: Determining Axle Length for 6 Foot 6 Inch Wide Trailer
- Q&A: Can I Install Trailer Wheels on my Truck to Match my Trailer
- Q&A: Difference Between an Idler Hub and a Hub/Drum
- Q&A: Troubleshooting Hub and Spindle Not Fitting Together after Replacing Spindle on a Utility Trailer
- Q&A: Recommended Axle-Less Trailer Suspension System For Trailer With Springs 42 Inches On Center
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices
- Article: How to Raise Your Travel Trailer Height
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Measure for Trailer Hitch Drop
- Article: Trailer Jacks
- Article: Trailer Tire Sizing