Brake Controller Install Harness Needed for Installing Prodigy P3 in 2017 Nissan Titan

Question

Question:

I upgraded from a 2016 Nissan Frontier to a 2017 Nissan Titan . Will the Tekonsha Progity P3 with adapter plug 3050 work or do i need to order the adapter 3050P , any differenence ? In comparing the new Titan wiring harness to the 2016 Frontier , the colored wires on the plug are in different locations when looking at them side by side ? L-Titan wiring Harness R-3050 Adapter Thanks

asked by: Hector A

0

Expert Reply:

The same install harness part # 3050-P fits your new 2017 Nissan Titan so you have everything you'd need to install the P3 part # 90195 in your vehicle.

Just swap the parts the Titan and you'll be good.

expert reply by: Jameson C

0

Answer 1

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

view full answer...

Answer 4

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 5

For all intents and purposes, yes, the Fulton drop leg stabilizer jack SJL80300 is the same as the square leg jack you asked about: - Square Drop Leg Stabilizer Jack - 18" Travel - 2,000 lbs #SJ-R208 Different manufacturers but otherwise they…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

We have one option that will work for you. The Trailer Hub and Drum Assembly - 4,400-lb E-Z Lube Axles - 10" Diameter - 6 on 5-1/2 #8-407-5UC3-EZ uses inner bearing #L68149 and outer bearing #LM67048 so it would work perfectly on your spindle.…

view full answer...

Answer 8

A cover being installed on your spare tire would not prevent the Swagman Bike Rack part #S80501 from installing. The rack would still fit and work well. You might still compare the dimensions in the picture I attached with you spare tire so that you…

view full answer...

Brake Controller Install Harness Needed for Installing Prodigy P3 in 2017 Nissan Titan

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching