Installing a Yakima HangOut 2 on a 2016 Jeep Renegade With Spoiler

Question

Question:

I have gone through the video for the installation of the hangout 2. I just wanted to clarify that the straps wont put too much weight on the top spoiler? Is there anything to be aware of when tightening straps down?

asked by: Imogene M

0

Expert Reply:

For the Yakima HangOut 2, part # Y02638, you'll want to uninstall the rack when it is not in use, as prolonged installation can wear the strength of the spoiler down over time, however, normal use and correct installation go a long way to protect your spoiler.

You'll want to make sure that the top hooks are correctly put into the "Anchor" mode. I've included the instructions on how to do that.

expert reply by: Jacob W

0

click to enlarge

Answer 1

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and…

view full answer...

Answer 2

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on…

view full answer...

Answer 3

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to…

view full answer...

Answer 4

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6-1/2 inch whereas the 225/75-15 fits widths that are 5 inch to 6 inch. The 205 is 27.1 inches tall and the 225 is…

view full answer...

Answer 5

A 4-way trailer connector will have four functions which means it will also have four wires for the exception of wishbone harnesses. These four functions are ground, tail light, right turn, and left turn. The ground function will usually be…

view full answer...

Answer 6

It really just depends on what the wires are for. Most likely you have several ground wires among the 8 as well as a couple running light circuits in there as well. You just have to run all of the wires to the correct circuits. The 4-way wiring of…

view full answer...

Answer 7

That is an excellent question and is asked more often than you think. Electric brakes like what come in the Electric Trailer Brake Kit #AKEBRK-2 can be submerged in water when you are loading/unloading your boat. Since water and electricity don't…

view full answer...

Answer 8

A 16 inch tire will not fit on a 16.5 inch wheel. You would either need to get new 16 inch wheels with the proper bolt pattern to match what the hubs require or to get your existing wheels you would need to go with 16.5 inch tires. You mentioned you…

view full answer...

Answer 9

Since the discontinued MaxxAir 4700k model fits a standard 14 x 14 RV vent opening, I recommend the MaxxFan Plus Roof Vent w/ 12V Fan - 10 Speed #MA00-04500K. The MaxxFan Plus comes with a thermostat and a remote for easy temperature customization.…

view full answer...

Answer 10

We only have the products listed on our website. I just double-checked to see if there was anything matching your descripton. The 4 microwave/convection/OTR ovens are all well over your 24" wide location. One of the smallest is the Furrion…

view full answer...

Answer 11

No, the Replacement Mounting Hardware #C75JR is not going to fit the Curt Class III Hitch #C13135. If you are in need of a hardware kit for the #C13135 hitch, we can provide that with Part #RHK. When you go to the page for #RHK you will see a box…

view full answer...

Installing a Yakima HangOut 2 on a 2016 Jeep Renegade With Spoiler

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching