Where Does Kat's Heater Install on Engine of 2012 Ford Edge Limited 3.5 V6
Question:
Hi. Want to know where to connect it to the engine ? do you have a diagram show where to plug it into engine. Thank you
asked by: SAAD A
0
Expert Reply:
I checked with Kat's and the location of the port that the # KH11409 installs in on your 2012 Ford Edge 3.5 liter V6 is on the passenger side of the engine behind the rear corner on the left side as you face the engine.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Kat's Heaters Custom Engine Block Heater - Frost Plug Style - 120V - 400 Watts - 3/4" NPT
- Vehicle Heaters
- Engine Block Heater
- Frost Plug Style
- 400 Watts
- CSA Approved
- Kats Heaters
more information >
Continue Researching
- Q&A: Location of Kat's Heater Install on 2010 Ford Edge
- Article: Trailer Tire Sizing
- Q&A: Where to Install Kat's Custom Engine Block Heater on 2015 Mazda CX-5
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Block Heater that Fits 2023 Mazda CX-9 and Where it Installs
- Q&A: Is Any Grease Needed When Installing Kat's Block Heater in Vehicle
- Q&A: Where is the Port for the Block Heater # KH11815 on a 2018 Ford F-150 with a 3.5L V6 EcoBoost Engine
- Q&A: Do Kats Block Heaters Come with Install Instructions
- Q&A: Recommended Weight Distribution System for a 7,500 lbs Travel Trailer and a Lifted Truck
- Article: Trailer Wiring Diagrams
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Article: My Trailer Hitch Doesn't Fit
- Article: How to Correct Noise from Exhaust Rattling Against a Trailer Hitch
- Article: Performance Chips and Modules