Dimensions of Kwikee 32 Series Double Step # LC3722617

Question

Question:

Is this step 24 inches wide? I need a replacement 32 series step for a 2004 Monaco caymen RV.

asked by: Don S

1

Helpful Expert Reply:

The Kwikee 32 Series Double Step # LC3722617 is 24 inches wide at each step but the frame it mounts to at the widest point is 25-1/4 inches. I've attached a photo to assist with all the dimensions.

expert reply by: Jason S

1

click to enlarge

Answer 1

The bolt does not come with the Replacement Foot Plate for Lippert Power Gear Hydraulic Jack #LC359344. I checked with Lippert, and while there isn't an OEM replacement bolt, they did say that the correct bolt was a Grade 8 3/4"-16 x 1-1/2…

view full answer...

Answer 2

For front air bags that fit inside of the coil springs on your 2002 Workhorse P32 chassis you will need #AL81560. You can roll up these bags and insert them up from the bottom through the hole below the coil spring mounts that you have described. No…

view full answer...

Answer 3

There is one key difference between the Blue Ox Patriot 2 Portable Braking System part BRK2016 and the Blue Ox Patriot 3 Portable Braking System part #BLU37TR. The difference is an extra safety measure built into the Patriot. The Patriot #BLU37TR has…

view full answer...

Answer 4

That is a strange issue to have. The issue may be with one of a few parts. It could be that the motor is stuttering before the steps are fully retracted causing them to retract as it thinks that it may be hitting something. The controller may be…

view full answer...

Answer 5

For a replacement step for what you have now that shows part number 725-0042 the correct set is the Kwikee 32 Double Step part #LC3722617.

view full answer...

Answer 6

It sounds like you might be looking for a replacement motor for your Kwikee steps with the 5973820 motor. We've confirmed that the #LC379608 is the correct motor to replace the one on your old steps. If you're wanting to replace the entire…

view full answer...

Answer 7

For the SCS Frigette Coach 733-0001 the motor replacement you mentioned is correct. For a replacement motor you would want the part #LC301695. You might make sure that the step isn't damaged mechanically too. If the linkage or steps are bent in…

view full answer...

Answer 8

I am attaching a picture that shows the dimensions for the Lippert Underchassis Double Bin Storage Unit #LC125460 that you referenced. You can use these to help you determine if/how it will fit on your 2018 Forest River Wildcat. The overall…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Dimensions of Kwikee 32 Series Double Step # LC3722617

Product Page this Question was Asked From

Continue Researching