Recommended Load Resistors for LED Lights Experiencing Hyperflashing
Question:
I just placed an order for STL60RB and STL60RLBP. Now Im hearing I might need some kind of flasher control? I am putting these lights on my 1994 Ford F-150 which has a flat bed style bed on it.
asked by: Ralph L
0
Expert Reply:
When adding LED lights to replace incandescent bulbs, there can be hyperflashing that happens because LED's draw so much less power than bulbs. Not every application experiences this issue, but if you do, I recommend Light Bulb Load-Resistors # DI34ZR on the functions effected.
expert reply by:
Jason S
0
Products Referenced in This Question
Load Resistor Kit for LED Turn Signals - 50 Watts - 6 Ohm - Qty 2
- Accessories and Parts
- Trailer Lights
- Load-Resistor Kit
- Diamond
more information >
Product Page this Question was Asked From
Jeep-Style LED Combination Trailer Tail Light - 4 Function - 52 Diodes - Passenger Side
- Trailer Lights
- Tail Lights
- Rear Reflector
- Stop/Turn/Tail/Backup
- Square
- Surface Mount
- Non-Submersible Lights
- LED Light
- 7L x 6W Inch
- Red/White/Amber
- Optronics
more information >
Continue Researching
- Article: Trailer Tire Sizing
- Q&A: Replacing Bearing Seals on Older DICO Hub and Drum
- Q&A: Replacement Lug Stud for Dico Trailer Hub Assembly 45263
- Q&A: Replacement Idler Hub For Old Boat Trailer With DICO 45264 Idler Hubs
- Q&A: Installation of Jeep-Style Trailer Lights
- Q&A: 7-Way For 2023 Toyota Highlander For Brake Controller
- Article: Trailer Maintenance Schedule
- Q&A: Where to Wire Breakaway Poles of Trailer Breakaway System
- Q&A: Are the Optronics Jeep Style Universal Trailer Tail Lights available in LED Version
- Article: Printable Trailer Bolt Hole Pattern Template
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today
- Article: Pintle-Hitches