Recommended Wiring Harness and Bracket to Upgrade 2014 Nissan Pathfinder to 7-Way
Question:
I installed part number 118670 on my 2014 Nissan Pathfinder and now I would like to upgrade to a 7 prong. Do I need to remove all of the interior wiring or can I just remove the exterior under the bumper wiring and hook up the 7 prong pig tails from there? Would the 4 pin/7 prong with bracket work with what I have also?
asked by: Chris
Expert Reply:
To add the 7-way to your 2014 Nissan Pathfinder, you will need the T-One Vehicle Wiring Harness for Factory Tow Package - 7-Way Trailer Connector # 118273. You will not need to replace the interior wiring of the # 118670 you already installed, but the wiring harness for the 7-way can only be found in this kit. If you want the 7- and 4-Pole Trailer Connector Socket w/ Mounting Bracket - Vehicle End # HM40975 this will connect directly to this wiring harness.
You may also be interested in the No-Drill Mount Bracket # 18140 to mount your connector.
Products Referenced in This Question
T-One Vehicle Wiring Harness for Factory Tow Package - 7-Way Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- No Converter
- Custom Fit
- 7 Round - Blade
- Tekonsha
more information >
No-Drill Mount for Electrical Mounting Bracket - Short
- Accessories and Parts
- Trailer Wiring
- Mounting Hardware
- Brackets
- 4 Flat
- 5 Flat
- 4 Round
- 5 Round
- Tow Ready
more information >
7- and 4-Pole Trailer Connector Socket w/ Mounting Bracket - Vehicle End
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- No Converter
- Custom Fit
- 7 Round - Blade
- 4 Flat
- Hopkins
more information >
Product Page this Question was Asked From
T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- No Converter
- Custom Fit
- 4 Flat
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams
- Article: Roadmaster Vehicle Specific Base Plates
- Article: Steel vs. Aluminum Ball Mounts
- Q&A: Replacement Air Conditioner for RV Duo Therm 57915.531
- Q&A: After How Many Years Should Trailer Tires Be Replaced
- Article: How to Measure for Trailer Hitch Drop
- Article: Frequently Asked Questions About Transmission Coolers
- Q&A: How To Wire and Install On-Board Auxiliary Trailer Battery to Power Lights
- Q&A: Recommended Replacement for 7.50-15LT Trailer Tire
- Q&A: Replacement Trailer Grease Seal for an NOK AD2527E Seal on a Boat Mate Trailer
- Q&A: How To Measure A Bolt Pattern On A Hub And Drum Assembly
- Q&A: Hub & Drum With Electric Brakes Replacement For AL-KO 8700 Hub