bing tracking image
Q & A Icon

Parts Needed to Install Brake Controller in 2017 Jeep Cherokee  

Question:

Do you sell a cable that will mate between the four flat socket female end of cable 3014-P and the four pin connector on a Tekonsha BRAKE-EVN controller, or can you tell me the part number and manufacture of the connector so I can make one myself, I trying to avoid cut and splice unless you think that would be better. résistance. voltage ,,,etc. Thank you

0

Expert Reply:

If you are trying to install a brake controller in your 2017 Jeep Cherokee all you'd need is the part # 3014-P as it is designed to attach to the vehicle at the brake controller port and then to the back of the Tekonsha BRAKE-EVN part # TK63VR.

There would not need to be any additional wires or harness to complete the install as long as you have a factory 7-way at the rear of your vehicle.

expert reply by:
0
Jameson C

Products Referenced in This Question


Product Page this Question was Asked From


Q & A Icon

Continue Researching

See More Q&A Expert Answers >>