License Plate Wiring Kit Compatibility with 1995 Dodge Dakota Sport Stock Bumper

Question

Question:

Will this license plate light kit work on a 1995 Dodge Dakota Sport with a stock bumper? Thank you!

asked by: Trevor

0

Expert Reply:

The Replacement License Plate Light Kit for Westin Bumpers - Chrome # 00007153 may work well with your 1995 Dodge Dakota Sport. The housing for the light itself is 1-3/4 inches wide at the center and 2.1 inches long so it will fit and cover the hole in the bumper. The retaining clip that holds the light in place is 1-1/2 inches wide and 1-3/4 inches long to retain the light. I've attached a photo to assist. As long as they fit the openings, this system will work very well for you.

expert reply by: Jason S

0

click to enlarge

Answer 1

The Replacement License Plate Light Kit #00007153 referenced in your question may work on your 1988 Chevy Silverado c1500 but it will depend on what type of bumper you have installed. This light is specifically designed Surestep or Diamondstep…

view full answer...

Answer 2

For your 2004 GMC Sierra 2500HD you would need a Westin Perfect Match Bumper Light Kit, part #00007271. This light kit is designed to work on a 2004 GMC Sierra 2500, that should have cutouts in the bumper for the lights that have square edges. The…

view full answer...

Answer 3

The Replacement License Plate Light Kit for Westin Bumpers - Chrome #00007153 is only tested for a fit on the Westin Perfect Match replacement bumpers. This doesn't mean that is the only fit because customers have put them on many factory…

view full answer...

Answer 4

I went out to the warehouse and pulled Westin Perfect Match Replacement Bumper License Plate Light Kit, #00007153, to take some measurements. The housing for the light itself is 1-3/4 inches wide at the center and 2.1 inches long so it will fit and…

view full answer...

Answer 5

Yes, the Replacement License Plate Light Kit #00007153 that you referenced will fit in a 1-1/4 inch hole and the clip that comes with it will secure the light to the bumper. Check out the picture I attached to see the dimensions of the clip and…

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

I would use a protractor, see photo, place the protractor on the edge of the inside of one side of the trailer frame and the other inside edge of the trailer frame should be parallel with the 50 degree line on the protractor. Another way to verify…

view full answer...

License Plate Wiring Kit Compatibility with 1995 Dodge Dakota Sport Stock Bumper

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching