Hole Diameters Needed to Install the Ultra Faucets Side Lever RV Kitchen Faucet # 277-000175
Question:
I am replacing the same design faucet non-metallic construction which as broken, in my 2011 Forest River 5th wheel. What hole diameters are required to install the main faucet as well as the water supply lever for this faucet 277-000175? The photos do not show a threaded stud for a washer and nut to hold the hot/cold water supply lever. How is that part secured to the counter top? Can you send a diagram?
asked by: Frank M
Expert Reply:
I went out to the warehouse and measured the underside of both the faucet and the lever for the Ultra Faucets Side Lever RV Kitchen Faucet with Pull Down Spout # 277-000175 that you referenced and found that you will need at least a 1-1/4" hole for the faucet and at least a 1-3/4" hole for the lever. Since each base is 2-1/8" you will want to make sure that your cut-out is less than 2-1/8" for the install.
I have attached a review video as well as some photos from the product page that show how the faucet installs and the unique design of how the lever installs. Both of these secure to the countertop by the included seal, washer, and nut.
