How to Extend the Wiring of a LT200 Superwinch # 1120210 on a 2005 Yamaha Wolverine 350 FX
Question:
The wiring for the Superwinch comes up about 12 short for the winch connections. What is the best way to extend the wiring leads? They look to be about a 10 or 12ga. Installing on 2005 Yamaha Wolverine 350 FX. Solenoid has been installed in the under seat tool box at the rear of the ATV. Wiring is running under RH side of frame. Thanks
asked by: Paul
Expert Reply:
The best way to extend the wiring would be to get 10 Gauge Blue Primary Wire, part # 10-1-1, to extend the wiring and then use a 12-10 Gauge Butt Connector, part # 05732-2, to connect the wires. And then finally wrap the connection with Electrical Tape.
That should give you the additional 12 inches you would need to connect your Superwinch LT2000 ATV Winch, part # 1120210, to your 2005 Yamaha Wolverine 350 FX.
I attached installation instructions for the # 1120210 below.
Products Referenced in This Question
Product Page this Question was Asked From
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Parts Needed to Install 7-Way on 2016 Ford F-150 with 4-Way
- Q&A: How to Install the Rear View Safety Backup Camera System
- Q&A: Cutout Dimensions Needed for Flush Mount Oval LED Trailer Lights
- Q&A: Wiring a Side Marker Light to the Running Light Wire on a Trailer
- Q&A: Parts Needed to Re-Wire 18 Foot Car Hauler Trailer with 7-Way Connector
- Q&A: Brake Magnet Clip Replacement for Trailer Brake Assembly
- Article: Most Popular Wheel Bearings
- Q&A: Do Electric Brakes Need to Share Ground Wire?
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)