Does Valterra EZ Valve Electric Waste Valve # E1003VP Install by Just Replacing Old Valve
Question:
Can I not just unbolt the old knife blade valve and slip it out and replace it?
asked by: Tom H
0
Expert Reply:
You'd want to remove your old valve and use ABS solvent bond like part # A05-0303 to install the part # E1003VP but it basically just installs in place of the old one.
expert reply by:
Jameson C
0
Products Referenced in This Question
Valterra ABS Solvent Cement - 1/4 Pint
- RV Sewer Hose Fittings
- Sewer Seals and Gaskets
- ABS Cement
- Valterra
more information >
Product Page this Question was Asked From
Valterra EZ Valve Electric Waste Valve for RV Black Water Tank - 3" Diameter
- RV Waste Valves
- Straight Valve
- Single Waste Valve - Manual
- 3 Inch Valve Body
- Stationary Valve
- Valterra
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: How to Choose the Correct Valterra EZ Valve Electric Waste Valve for RV Black Water Tank
- Q&A: Parts Needed to Activate 12 Volt Charge Circuit of 7-Way on 2022 Tiffin Wayfarer on Sprinter Chassis
- Q&A: Can Center Section of Electric Waste Valve E40B-8 Replace Manual Setup
- Q&A: Is Sealant Required for the Replacement Rubber Grommet for RV Black Water Tanks
- Q&A: Is There Enough Tension in Rolled Up Solera Awning to be Dangerous
- Q&A: Adding Tension To The Tension Springs On A Solera Slide Topper Awning
- Q&A: Can a Valterra Waste Valve Be Used in Place of a Bristol Waste Valve
- Article: Cleaning Your RV Black Water Tank in 4 Easy Steps
- Article: How Does an RV Water Pump Work?
- Article: 5 Tips to Confidently Choose Your Weight Distribution Hitch
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: 4 Reasons Not to Use RV Solar Power (And 4 Reasons You Should)
- Article: How Much Solar Power Do I Need For My RV?
- Article: How to Choose the Right Trailer Hitch Class