Will the Air Lift LoadLifter 5000 Part # AL57295 Work with a Pullrite Superglide 5th Wheel Hitch

Question

Question:

Do you have any info if this will fit my truck...the issue is i have a Pullrite Superglide 5th wheel hitch and the mounting brakets are bolted to the frame right where the air lift bracket would go and i am concerned about interference.

asked by: Wally D

1

Helpful Expert Reply:

The Air Lift LoadLifter 5000 Air Helper Springs part # AL57295 mount in place of the factory bump stops on your 2004 Dodge Ram 2500. Therefore, yes, the Air Lift LoadLifter 5000 Air Helper Springs will work with the Pullrite Superglide 5th Wheel Hitch installed on your Ram.

I have attached an installation video of these air bags installed on a 2006 Dodge Ram for you.

expert reply by: Conner L

1

click to enlarge

Answer 1

The correct Air Lift LoadLifter 5000 Air Helper Springs for a 2011-2016 Ford F-250/F-350 (4x4) is part #AL57396. The correct Air Lift LoadLifter 5000 Air Helper Springs for a Dodge Ram 2500 is part #AL57295. These kits do both use the same airbag so…

view full answer...

Answer 2

If you are having an issue bottoming out, I recommend the Air Lift LoadLifter 5000 part #AL57295. It's specifically designed for 3/4-ton and 1-ton pickup trucks, motor homes, and commercial trucks and will provide your Dodge Ram with up to 5,000…

view full answer...

Answer 3

The side plates of the gooseneck trailer hitch #BWGNRK1313 will mount on the outside of each frame rail. See diagram to the right and video (start it at 7 minutes and 30 seconds). You could choose to spring for a new suspension kit for your 2004…

view full answer...

Answer 4

According to my contact at Air Lift, the LoadLifter 5000 System you mentioned, part #AL57295 is indeed compatible with your 2011 Ram 2500 Big Horn with the Curt 5th wheel hitch. The system mounts to the bottom of the frame members, and therefore will…

view full answer...

Answer 5

Yes, the AirLift LoadLifter 5000 Air Helper Springs part #AL57268 are a fit for your 2017 Ford F-150 5 1/2 foot bed with a B&W Turnover ball install part #BW77FR if your truck has 4WD. We do not have an installation video at this time that shows…

view full answer...

Answer 6

I have a good solution but the Air Lift LoadLifter 5000 Air Helper Springs part #AL57297 as you said will not work with the B&W you have installed. Instead you want the Air Lift LoadLifter 7500 XL Air Helper Springs part #AL57595 these use a…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

It sounds like the purpose of getting the air helper spring would be to counteract the 1 inch compression you're getting in your rear suspension caused by the pin weight of your 5th wheel. If that's the case, I believe that the AirLift 5000…

view full answer...

Answer 10

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 11

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 12

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...