Replacement Trailer Hubs and Electric Brakes for 2007 Prestige Inc Boat Trailer

Question:

Hello! I have 2007 EZ Loader boat trailer STI-S185W V.I.N. 4JHBS181872000361 with UFP axle A357201. Bolt pattern is 5 on 4-1/2. I hope this AKHD-545-35-K is OK for my trailer but don`t sure. Mounting flange has 4 holes with spacing around 3 inches I dont have instrument to get more precision measurement. I would like to get your advice what part assembly should I get ? Than you!

asked by: EVGENY K

Expert Reply:

If your trailer has a 3,500 pound axle with 5 on 4-1/2 inch bolt pattern hubs, then the etrailer.com Trailer Hub and Drum Assembly # AKHD-545-35-K should be the correct replacement hub and drum assembly. This hub uses the # L68149 inner bearing and # L44649 outer bearing. I recommend pulling the hubs on your trailer and checking the existing bearing numbers to ensure this is a match. The numbers should be stamped onto the bearings themselves.

If you cannot locate the numbers, you can also measure the spindle at various locations using a digital caliper like # PTW80157. I have attached an image that shows where the measurements will be taken.

Then for compatible electric brake assemblies, I recommend the etrailer.com Self Adjusting Assembly # AKEBRK-35R-SA for the Right Hand and # AKEBRK-35L-SA for the Left Hand. These self-adjusting brakes do not require periodic manual adjustments like standard brakes.

I was unable to locate specific information on your 2007 trailer. It appears that the trailer was actually manufactured by Prestige Trailers, Inc - which are no longer in business.