Will the Foam Blocks From the Rightline Kayak Carrier Fit Yakima JetStream Crossbars

Question

Question:

Do you know if this foam block will fit on Yakima Jet Stream Rack? Thanks,

asked by: Greg O

0

Expert Reply:

Yes, the Rightline Kayak Carrier with Tie-Downs # RL100K10 will work with naked roofs and round, square, aero, elliptical, and most factory crossbars. The Yakima JetStream Crossbars, like part # Y00426, have a normal Aero shape to them so they will be compatible with the foam blocks.

expert reply by: Jon G

0

Answer 1

I do have a way that you can carry 2 kayaks on your 2019 Toyota Highlander but when I checked out the online version of the owner's manual on page 204 it states not to exceed 165 lbs of weight on the roof rack. Since your 2 kayaks have a…

view full answer...

Answer 2

There is not a general restriction from Thule that says two Hullavator Kayak Carriers #TH898 can't be used on a Thule roof rack. As long as the crossbars on your Ford Escape have the required length for two sets and a sufficient weight…

view full answer...

Answer 3

There are a couple of differences between the two. The JetStream bars like #Y00425 are made of extruded aluminum while the CoreBars such as the #Y00421 you've looked at are constructed of galvanized steel. As you've mentioned, the…

view full answer...

Answer 4

The Thule Hullavator Pro Kayak Carrier #TH898 is only compatible with the Yakima CoreBar crossbars if you also use the mounting kit #TH7520970001. Just be sure that you have the proper clearance (4" - 8" beyond the feet) for this to…

view full answer...

Answer 5

The Thule Hullavator load-assisted kayak carrier #TH898 will directly mount onto just about any roof rack bar shapes, including round, square, aero, elliptical, most factory crossbars, and most crossbars with top "T-slot" channels. Yakima…

view full answer...

Answer 6

I would love to help you upgrade the suspension on your Twilight 2800 travel trailer. The MORryde Rubber Equalizers for Tandem Axle Trailers #MR87ZR that you referenced are a great solution but we do need to double check a few things. First is that…

view full answer...

Answer 7

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 8

The temperature light on your Everchill RV Refrigerator w/ Freezer #324-000119 is likely flashing because of a lack of full power to the fridge. The fridge requires 11 amps. It is likely trying to use more power than what is available which is why…

view full answer...

Answer 9

The Trailer Hub and Drum Assembly part #AKHD-545-35-K is the correct replacement for an AL-KO 7230. In regards to the braking assemblies, I suggest getting a new pair, the Electric Trailer Brake Kit part #AKEBRK-35-SA. This option will save you some…

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

Aside from a slight change in the appearance of the crossbar (the WingBar Evo has some boxed edges as opposed to the completely smooth front of the AeroBlade) the biggest differences are the rubber strip on top of the crossbar and the weight…

view full answer...

Answer 12

For a roof rack to be compatible on your 2020 Jeep Wrangler with Sky One-Touch Power Top, it can't be mounted on the top of the roof and it needs to be high enough for the folding roof to clear. What you need are tall gutter-mounted roof racks.…

view full answer...

Will the Foam Blocks From the Rightline Kayak Carrier Fit Yakima JetStream Crossbars

Products Referenced in This Question

Featured Help Information

Miscellaneous Media

Continue Researching