Replacement Carbon Monoxide Detector for RV

Question

Question:

I am trying to locate a replacement carbon monoxide alarm for my COSTAR model 12RV-D from my 2004 FLEETWOOD FLAIR motor home. Can you help?

asked by: Rodger W

0

Expert Reply:

If you need a propane gas and carbon monoxide detector you can use the RVSafe # RS34FR unit. It is also available in black # RS54FR adn a three-wire system # RS94FR.

expert reply by: Adam R

0

Answer 1

The Atwood RV carbon monoxide and propane gas detector you mentioned is no longer made so we are unable to get it at this time but we do have the similar white part #RS34FR which would also work great.

view full answer...

Answer 2

I don't recommend converting a wired home alarm to an RV. The issue is home alarms typically use 120v where you will want the 12v alarm for your RV. I recommend using the Atwood RV Carbon Monoxide and Propane Gas Detector - 12 Volt - White…

view full answer...

Answer 3

See the linked item below for my recommendation: **2-Wire RV Propane Gas and Carbon Monoxide Detector - 12 Volt - White #RS34FR. The three wires are two red and one black. Black is ground and the red are for power. Only one red is needed however as…

view full answer...

Answer 4

You can use the RV Propane Gas Detector #RS64FR to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

I recommend the #RS34FR to replace your current LP gas detector. This is a simple 2 wire design making for easy installation.

view full answer...

Answer 7

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 8

Hey Richard, thanks for reaching out! The Dexter DX7.5 Drop-N-Go Brake Actuator #099-175-00 is a great option for a replacement actuator because it's a direct replacement for the common Model 60 actuators that were popular in the '90s.…

view full answer...

Answer 9

We do have some LP gas detectors available, but none would be a direct replacement for your CCI 7770.2 / Pre Tell 22. From what I could find on your CCI 7770.2 / Pre Tell 22, it has dimensions of 6.25" wide x 3.9" tall. The RV Propane Gas…

view full answer...

Answer 10

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 11

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 12

Traditionally, trailer manufacturers did not use electric brakes on boat trailers because the brake magnet wiring and trailer wiring did not always have the best insulation or water protection. These days, more and more manufacturers are using…

view full answer...

Replacement Carbon Monoxide Detector for RV

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching