Is Additional Plunger Pin Needed with the Bulldog Powered-Drive Trailer Jack BD500188
Question:
I purchased the BullDog BD500188. It can with a pin and safety lock for the leg, however the instructions say it should have a Plunger Pin Assembly. Need to know if this is available for purchase or is the pin and safety catch sufficient Would appreciate your help Thanks
asked by: George W
0
Expert Reply:
The snapper pin that comes with the Bulldog Powered-Drive Trailer Jack # BD500188 that you have would be sufficient to hold the drop leg to the outer leg of the jack.
You would not need to replace it with a plunger type pin.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Bulldog Powered-Drive Trailer Jack - Drop Leg - A-Frame - 21-3/4" Lift - 3,500 lbs - White
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jack
- Steel
- 3001 - 4000 lbs
- Electric Jack
- 22 Inch Lift
- Bolt-On
- 1 Jack
- Bulldog
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Replacement Entry Door Lock On A 2004 Featherlight Horse Trailer
- Article: Flat Towing Package for 2012-2014 Honda CR-V
- Article: Best Camper Jacks
- Q&A: Is There a Power A-Frame Jack That Can Rotate 90 Degrees
- Q&A: Using Vehicle Battery To Power Trailer Tongue Jack.
- Q&A: Availability of Replacement Drop Leg for Bulldog BD500188 Powered Trailer Jack
- Q&A: Is There a Difference Between Using etrailer Tongue Weight Scale at Coupler and Trailer Jack
- Q&A: Is Weight Distribution System Needed for 2018 GMC Sierra 1500 Towing Cherokee Wolf Pup
- Q&A: Etrailer Tongue Weight Scale VS. Sherline Tongue Weight Scale
- Article: Basics of Tie-Down Anchors
- Article: How to Measure for Trailer Hitch Drop
- Article: Trailer Jacks
- Article: How to Raise Your Travel Trailer Height
- Article: What is Boondocking