Is the Timbren Axle-Less Suspension A35RS545 Compatible with Hydraulic Disc Brakes
Question:
can you use hydraulic disc brakes with A35RS545
asked by: Robert
Expert Reply:
Yes, you most certainly can use hydraulic disc brakes with the Timbren Axle-Less Trailer Suspension System w Hubs # A35RS545.
This Timbren system already has a brake mounting flange installed on it so if you already have your trailer setup with disc brakes that install on a 4 bolt brake mounting flange, like the Kodiak Disc Brake Kit # K2R35D, then you will be good to go.
Otherwise you can use a disc brake kit that uses the common surge actuator, like the Titan Disc Brake Kit # T4843300, or for a better system you can use the Titan Disc Brake Kit # T4843800 which uses an Electric-Over-Hydraulic (EOH) configuration. For the EOH system you will also need a brake controller like the Prodigy P3 # 90195 as well as a fully functioning 7-Way on both your trailer and tow vehicle.
If your trailer or tow vehicle do not have the 7-Way just let me know and I can make some recommendations for you.
I have also attached some review/installation videos and helpful articles on brakes for you to review.
Products Referenced in This Question
Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LCD Display
- Up to 360 Degrees
- Tekonsha
more information >
Kodiak Disc Brake Kit - 10" Rotor - 5 on 4-1/2 - Dacromet - 3,500 lbs
- Trailer Brakes
- Disc Brakes
- Marine Grade
- 5 on 4-1/2 Inch
- Rotor
- 3500 lbs Axle
- 14 Inch Wheel
- 14-1/2 Inch Wheel
- 15 Inch Wheel
- Kodiak
more information >
Product Page this Question was Asked From
Timbren Axle-Less Trailer Suspension w Idler Hubs - Standard Duty - No Drop - 5 on 4-1/2 - 3,500 lbs
- Trailer Axles
- Rubber Spring Suspension
- Easy Lube Spindles
- Idler Hubs
- 3500 lbs
- 5 on 4-1/2 Inch
- Universal Fit
- No Drop or Lift
- Timbren
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Trailer Tire Sizing
- Article: Trailer Wiring Diagrams
- Q&A: Parts Needed To Convert Oil Bath Hubs On EZ Loader Boat Trailer To Grease
- Q&A: Could the Timbren Axle Less System A35RS545 Fit a 1984 Starcraft
- Article: Most Popular Wheel Bearings
- Q&A: Installing a Timbren Silent Ride System
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Will The AM31990 Tire/Wheel Fit On The etrailer Hitch Mounted Spare Tire Carrier e98ZR
- Article: 2023 Holiday Must Haves
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Does Lippert Shock Kit Fit Enclosed Trailer with Boxed Frame
- Q&A: Timbren Axle-Less System With 2,200 lb Capacity Compatibility With Dexter Brake and Hubs K71-511-00
- Q&A: Can Kenda KR25 Tires Be Ran at Lower PSI Rating for Better Towing on a Small Cargo Trailer
- Article: How to Measure a Trailer Axle