Can Hopkins Endurance 7-Way Blade Trailer Connector # HM48500 Accept 10 Gauge Wire
Question:
Will this part accept larger wires , my travel trailer has a ground and postive that are larger wires than the other wires. Checking to see if this part number has a better system of accepting larger wires than the other models. Hopefully you can understand my question. Thanks,
asked by: Terry G
1
Helpful Expert Reply:
You could easily run 10 or 12 gauge wire to the Hopkins Endurance 7-Way Blade Trailer Connector # HM48500 that you referenced. I attached a picture that shows 12, 10 and 14 gauge wire ran to tit.
expert reply by:
Jameson C
1
click to enlarge
Product Page this Question was Asked From
Hopkins Endurance 7-Way Blade Trailer Connector w/ Holder - Trailer End - Ergonomic Design
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- Plug Only
- 7 Round - Blade
- Hopkins
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: What Is The Speed Rating On The Kenda 5.30-12 Bias Trailer Tire # AM30710
- Article: Trailer Wiring Diagrams
- Article: Most Popular Wheel Bearings
- Q&A: Wire Colors for Optronics Thinline LED Trailer Tail Light # STL64RB
- Q&A: Adding Reverse Lights on Boat Trailer to Maintain Reverse Lockout on Coupler
- Q&A: How Far In Do The Rails Of The TruXedo Sentry CT Hard Tonneau Sit In The Bed Of A Truck
- Q&A: Which Pin On a 2018 Ford F-150 Trailer Connector Is For Reverse Lights
- Q&A: Is Black Terminal for Trailer Wiring Junction Box Used for Reverse Light Circuit
- Q&A: How To Charge Your Breakaway Switch Battery On Your Trailer
- Article: Cleaning Your RV Black Water Tank in 4 Easy Steps
- Article: Dielectric Grease Review
- Article: Trailer Hitch Receiver Sizes
- Article: Brake Controller Installation: Starting from Scratch
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV