What is the Gear Reduction of the 12-Volt Motor Kit for Ram Landing Gear

Question

Question:

Like the Q and A question of Kris L.inch I would like to apply this motor kit to another application. If I can get the output rpm of the unit, not motor speed, or the gear reduction and motor speed as given, I can compute the actual output speed of the unit. This info would allow me to determine what I will need to apply this unit to the other application. Thanks

asked by: Loren L

0

Expert Reply:

In the question that you referenced the RPM was 5400-7200. I contacted the manufacturer and and found that the 12-Volt Motor Kit for Ram Landing Gear # LC142178 has a gear reduction of 3:1.

expert reply by: Jon G

0

Answer 1

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 2

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 3

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 4

It could be the motor but it could also be the screw/nut inside the jack leg that is causing the problem. Since you mentioned that it is hard to crank it manually I suspect that it is likely the screw and/or nut. On jacks that have an ACME screw the…

view full answer...

Answer 5

Yes, the Replacement Motor for Stromberg Carlson Electric Landing Gear #LG-142178 has been confirmed to replace the ADTH 1RV-200 landing gear motor you currently have so it would work for you.

view full answer...

Answer 6

The Replacement Motor for Stromberg Carlson Electric Landing Gear - 5,500 lbs #LG-142178 is the correct replacement motor for the discontinued Atwood 75721. The #LC141893 you asked about will also work and is a higher speed motor so it will give you…

view full answer...

Answer 7

While I'm not Rachel, I can tell you a compatible replacement for your landing gear motor MQ887 is the following part: - Replacement Motor for Stromberg Carlson Electric Landing Gear #LG-142178

view full answer...

Answer 8

I spoke with my contact at Trailair and from your serial number we were able to determine that your trailer came with a 1621 HD pin box which is a long pin box style. I was unable to obtain the exact part number for your Trailair pin box but from the…

view full answer...

Answer 9

The Replacement Motor for Stromberg Carlson Electric Landing Gear - 5,500 lbs item #LG-142178 you were looking at is the correct replacement motor for the discontinued Atwood 75721. The Gearbox for Venture Electric 5th Wheel RV Landing Gear…

view full answer...

Answer 10

The side plates on the 3" Wide Continuous Hinge #MA65VR you found are 0.09" thick which is just under 3/32". We do have a 3" Wide #MA52VR which is 6' Long with a 1/2" pin that has 0.18" thick side plates which is…

view full answer...

Answer 11

I am sorry but we do not have an AC cover with those dimensions. The closest option we have is the Replacement RV Air Conditioner Cover for Penguin and Dometic Air Conditioners item #AT3308046006 which measures 40-1/2" long x 29" wide x…

view full answer...