Connectors Needed for Connecting Husky Brute Jack to Trailer Battery Post
Question:
I am trying to wire a Brute 4500 electric jack to a camper. The jack has a single wire to run to the battery and a red breaker or relay to wire into it as well. I understand that but I do not know how I attach the single wire to the battery? Do I need to buy a battery post connection of some type to splice onto the end of the jack wire? Not sure how to connect the end of this jack wire to the battery post...
asked by: Kevin
Expert Reply:
If you have top posts you can use the part # DW05418 to give you an additional post on top of the terminal bolt that a ring terminal part # 44-5356A will fit. Almost all batteries out there will use this style of post.
Products Referenced in This Question
Ring Terminal - 12-10 Gauge Wire - 5/16" Ring ID
- Wiring
- Wire Connectors
- Ring Terminals
- 5/16 Inch Diameter
- 12-10 Gauge
- Flint Hill Goods
more information >
Product Page this Question was Asked From
Brass Battery Terminal Bolt Extender - Top Post Terminal - 5/16"-18 Thread x 1-7/16" Long
- Accessories and Parts
- Battery Boxes
- Bolt Extenders
- Deka
more information >
Continue Researching
- Q&A: Installation Instructions For The JR Products RV Cabinet Door Struts # 37270545
- Q&A: Factory Brake Controller Plug Location for 2019 Ford F-550 Chassis
- Q&A: Replacement 14,000 lb. Hydraulic Jack Assembly for Lippert Level Up Systems
- Q&A: Recommended Replacement for a Magnetek Model 6325 Converter
- Q&A: Can Atwood OD-5001 Water Heater Valve Assembly Be Replaced
- Q&A: Parts Needed For Brake Controller Installation On a 2021 Ford E-450 Cutaway Chassis For Class C RV
- Q&A: Brake Controller Wiring for Ford E-450 Motorhome
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Brake Controller Installation: Starting from Scratch