Can 30 amp to 110 Volt Power Cord Adapter Power Air Conditioning and Microwave

Question

Question:

is it safe to use a 30 amp to 110 volt adapter to run you travel trailers AC, microwave as well as lights ?

asked by: William C

0

Expert Reply:

The part # A10-1530DVP will easily handle the amperage of the accessories you mentioned. I attached a review video for this adapter for you to check out as well.

expert reply by: Jameson C

0

Answer 1

I looked up the specs of your Coachmen Clipper 108ST and found that it is listed at 16 feet, 4 inches long. For this size you have a couple of options. You can use Classic Accessories Deluxe PolyPro III Heavy-Duty Pop-Up Camper Cover Item #CA80042 or…

view full answer...

Answer 2

In order to make sure we get the best fit cover for your Forest River Rockwood 2317G, I would need you to measure the dimensions of your box while closed. Please do not include the tongue of the trailer or the height from the ground, just the…

view full answer...

Answer 3

Yes, the Replacement Pigtail Adapter for Kwikee Electric RV Steps - 2 Wire - 6" item #LC369413 is the correct replacement adapter for the LCI 366043 motor that goes with the 32 Series Kwikee RV Electric Steps item #LC3722617.

view full answer...

Answer 4

I took a look at the online version of the owner's manual for your 2018 Ford F-150 and was able to locate the wiring color code for the factory 7-Way trailer harness on the truck. The wires leading up to the factory plug are as follows: Yellow -…

view full answer...

Answer 5

Factory wiring could be any color since there is no one standard that all manufacturers follow. You will need to test the wires by function using a circuit tester such as #PTW2992 if you do not already have one. I have included a picture that shows a…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 8

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 12

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Can 30 amp to 110 Volt Power Cord Adapter Power Air Conditioning and Microwave

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching