How Tight Should the Nuts be for Lippert Shock # LC283271
Question:
How tight should the stem nuts be or what percent should the rubber bushing be compressed?
asked by: Bob R
1
Helpful Expert Reply:
You will tighten the hardware for shock # LC283271 until the rubber grommets have the same diameter as the washers. They are close to the same diameter to begin with so be careful not to overtighten them.
expert reply by:
Michael H
1
Product Page this Question was Asked From
Lippert Standard Replacement Shock - Black
- Accessories and Parts
- Trailer Suspension Parts
- Shocks
- Lippert
more information >
Continue Researching
- Q&A: Replacement Shock for Dexter Axle 052-003-00
- Q&A: Replacement Shocks For a 2008 Forest River Rockwood 232XR Pop Up Toy Hauler
- Q&A: Measuring to Determine the Right Size Shock to Use on a Trailer
- Article: Adding Electric Over Hydraulic Disc Brakes
- Q&A: Shock Kit that fits 2020 Jayco Eagle HT 28.5RSTS with Shock Prep
- Q&A: Will the Replacement Dexter Bolt-On Shock Kit Fit a 2011 Heartland Landmark
- Q&A: Picking Out Replacement Shock for 2003 Hitchhiker II Trailer
- Q&A: Availability Of Replacement Bolts And Shackles For Lippert Center Point
- Article: RV Sway Control, Stabilization, and Suspension Enhancement
- Article: How to Raise Your Travel Trailer Height
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: What Does it Mean When an RV is Solar Ready?
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices
- Article: Double-Eye Trailer Suspension System Review