Will Stihl BR200 Leaf Blower Fit Pack'Em Rack for Open Utility Trailers

Question

Question:

Do I need a bracket for a STIHl BR200 with the Pk-6-op1?

asked by: Darrell P

0

Expert Reply:

Adapters are required for STIHL 420, 550, and 600, ECHO or RedMax backpack blowers but not for other models such as your BR200

You shouldn't have any issues using it on the Pack'Em Rack for Open Utility Trailers, Part # PK-6-OP1.

expert reply by: Jeffrey L

0

Answer 1

According to Rack em, the ECHO PB-500T does not require an adapter but they do not list the PB-500H so an adapter would be needed. The adapter that fits Stihl and Echo models is #RA-STIHL.

view full answer...

Answer 2

Yes, the Pack'Em Rack for Open Utility Trailers #PK-6-OP1 will work with no additional parts. However, adapters are required for certain blowers, STIHL 340, 350, 550 and 600 models require #RA-STIHL. If you don't have these products you…

view full answer...

Answer 3

Yes! According to my technical contact at Rackem, your Stihls Backpack Blower BR200 will fit Rackem #RA-19. You will not need any additional adapters or brackets.

view full answer...

Answer 4

The Pack'Em Trimmer Rack part #PK-6S installs directly on the trailer's side rail (see photo 1). The Pack'Em Expansion Pack part #PK-OP1 installs on a set of uprights like the Pack'EmTower Kit for Pack'Em Racks part #PK-BM (see…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 8

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 11

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 12

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Will Stihl BR200 Leaf Blower Fit Pack'Em Rack for Open Utility Trailers

Product Page this Question was Asked From

Continue Researching