Troubleshooting Wiring On 2003 Ford Ranger After Installing Brake Controller Wiring
Question:
I put a 7 pin trailer hookup on my 03 ford ranger with a break controller. My right turn signal has my lights looking like flashers.the truck came with a 4 pin. I cut it off and tapped on those.
asked by: Mike K
Expert Reply:
I have attached a drawing that shows how wiring should be run when installing a brake controller and adding a 7-way wire harness to a vehicle.
For your 2003 Ranger we recommend using part # ETBC7 for the wiring when you go from a 4-way to a 7-way. The # ETBC7 kit includes the circuit breakers needed and also includes a circuit tester to make sure you are using the correct wires. If you do not have one, I recommend a circuit tester like part # PTW2993.
It sounds like you may have a short in the wiring somewhere or a problem with the ground. Check all of your wiring and make sure there are no breaks or bare spots in the wiring and no kinks or sign of damage. Check the ground wires on the lights and in the trailer harness wiring to make sure they are secured to clean metal surfaces. Then check all of the connectors for any signs of corrosion or damage.
Products Referenced in This Question
Product Page this Question was Asked From
Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Accessories and Parts
- Trailer Brake Controller
- Installation Kits
- etrailer
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: How to Choose the Right Trailer Hitch Class
- Article: How to Measure for Trailer Hitch Drop
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Where Do the Wires on the Universal Install Kit for Trailer Brake Controllers Get Installed?
- Q&A: 2022 Toyota Highlander Wiring for a 7-Way Blade Connector
- Q&A: Should I Get a Proportional or Time-Delayed Brake Controller
- Q&A: Parts Needed to Tow Trailer With Brakes Using 1992 Dodge D250
- Q&A: 4-Flat Trailer Wiring For 2024 Jeep Wrangler With Tow Bar Wiring