Recommendation to Extend Factory 7-Way to Fit with New Bumper on 2010 Ram 2500
Question:
I have a 2010 ram 2500 that I put a 2015 rear bumper on. The trailer wiring is on the right side vs left side on factory 2010. So what I need is a adapter that would extend the factory wiring about 12 inches, and retain the factory plug.
asked by: Kory
Expert Reply:
There are a couple of options to extend the factory wiring at the rear of your 2010 Ram 2500 so that it can reach the new connecter opening on the 2015 bumper.
The easiest solution is to use a 5th Wheel Wiring Harness like the Curt # C56070. This will plug in-line with your existing factory wiring and provide an extended harness on the other end. The only drawback on this option is that the Curt # C56070 represents the shortest 5th Wheel Harness that we offer at 7 feet long. So you will need to wrap up a decent amount of excess wire with some zip ties like # DW05727-25 after the necessary length is reached.
Another option is to use the Pollak Wiring Harness Extension # PK11-934. This is much shorter at 3 feet, but you will need to hardwire one end into a new connector like the Hopkins # HM48480. The other end will plug directly into your factory 7-way wiring harness.
Products Referenced in This Question
Deka Cable Ties Kit - UV-Resistant - Black - 50 lb Tensile Strength - 14" Long - Qty 25
- Electrical Tools
- Cable Management
- Cable Ties
- 14 Inch Long
- Black
- Deka
more information >
Hopkins Endurance 7-Way Trailer Connector Socket - Vehicle End - Ergonomic Design
- Trailer Wiring
- Trailer Connectors
- Vehicle End Connector
- Plug Only
- 7 Round - Blade
- Hopkins
more information >
Pollak Wiring Harness Extension - 7-Way RV - 3' Long
- Trailer Wiring
- Trailer Connectors
- Vehicle End Connector
- 0 - 5 Feet Long
- Plug and Lead
- 7 Round - Blade
- Pollak
more information >
Product Page this Question was Asked From
Curt 5th Wheel/Gooseneck Custom Wiring Harness w/ 7-Pole Connector - 7' Long
- Custom Fit Vehicle Wiring
- Fifth Wheel and Gooseneck Wiring
- 7 Feet Long
- Custom Fit
- 7 Round - Blade
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Trailer Wiring
- Shop: Curt 5th Wheel/Gooseneck Custom Wiring Harness w/ 7-Pole Connector - 7' Long
- Video: Curt 5th Wheel Wiring Harness Installation - 2014 Ford F-250 and F-350 Super Duty
- Q&A: Replacment Motor for Pump Assembly on Lippert LCI Pump 650057
- Q&A: Recommended Replacement For An Atwood GC6AA-10E Water Heater
- Article: Ram Trailer Tow Prep Package
- Q&A: Is 18,000 lb B&W Patriot Slider Enough For 12,000 lb 5th Wheel on 2016 GMC Sierra 2500
- Article: Sidewinder with Rotating Turret for Short Bed Pickups
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Gooseneck to 5th Wheel Adapters
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Recommended Replacement Jack for AL-Ko MD285 Trailer Jack
- Q&A: Wiring Diagram for 7-Way Wiring Harness C56070 to Install in Truck
- Article: Trailer Wiring Diagrams
- Q&A: Recommended In Bed 7-Way for a 2024 Ram 2500
- Q&A: Recommended In-Bed 7-Way Trailer Connector for 2022 Ram 3500