Parts Needed to Install a Brake Controller in a Former Greyhound Bus
Question:
I have a 1963 GMC PD4106 Coach, formerly a Greyhound bus, with an RV conversion. I am looking to install a trailer wiring kit. I just purchased one from you for my 2005 Jeep Liberty. What an easy install. Anything like that for the bus. Is it difficult to do a brake controller as well?
asked by: Mike G
Expert Reply:
We don't have any custom fit kits that are designed for your greyhound bus. You are going to first need to start with a 4-way though. For that you would need the part # 119250KIT and then would need to use the # ETBC7 to convert to a 7-way and install the brake controller.
I attached a couple help articles on installing brake conrollers for you to check out as well. You are most likely going to need a much longer section of wire than what comes with the ETBC7 for running the output circuit so for that you would want the part # 10-1-1 which is 10 gauge wire sold by the foot.
For a brake controller I would recommend the Prodigy P2 Brake Controller part # 90885. This is our best selling brake controller because of how well it works and how easy it is to setup. This is a proportional brake controller that senses the amount of braking the tow vehicle is applying and applies a proportionate amount to the trailer brakes.
Products Referenced in This Question
Tekonsha Prodigy P2 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LED Display
- Up to 360 Degrees
- Tekonsha
more information >
Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Accessories and Parts
- Trailer Brake Controller
- Installation Kits
- etrailer
more information >
Product Page this Question was Asked From
ZCI Circuit Protected Vehicle Wiring Harness w/ 4-Pole Flat Trailer Connector and Installation Kit
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Converter
- Universal Fit
- 4 Flat
- Tekonsha
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: Stability Control for Heavy Duty Vehicles
- Article: Testing Trailer Brake Magnets for Proper Function
- Q&A: Which Bolt Locking Hitch Pin Can be Keyed to a 2014 GMC Sierra 1500
- Q&A: Adjusting Dexter 10K Electric Trailer Brakes
- Q&A: Does BOLT Trailer Hitch Receiver Lock For GM Center Cut Key Fit 2021 Chevy Silverado
- Q&A: Will Bolt Trailer Hitch Lock part # BL7023582 Fit 2-1/2 inch Hitch on a 2011 GMC Sierra
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Replacement Antennas for Voyager WiSight Wireless Backup System
- Q&A: Replacement Microwave for Highpoint # EC942K9
- Q&A: Replacement Microwave for my High Pointe EC942K9E in Stainless