Can The Trailer Valet Be Purchased And Shipped To Florida?

Question

Question:

Can this product be purchased after Christmas around the middle of January and shipped to Florida?

asked by: John W

0

Expert Reply:

Yes. The Trailer Valet 5X Swivel Jack and Trailer Mover - Topwind - 15" Lift - 500 lbs, # STC-V211, will still be available in January. This is a product we keep on hand, and have had very good feedback from customers regarding. Yes, we can and do ship to Florida.

expert reply by: Jason S

0

Answer 1

In order to mount the Trailer Valet Swivel Jack and Trailer Mover, #STC-V211, on your trailer you will need at least 8 inches of free space on the tongue. I have included a picture with some measures listed. As long as you have sufficient clearance…

view full answer...

Answer 2

What you need is a little bit of momentum to get the boat trailer over the lip of your garage floor. If you can get the trailer moving at a decent speed (while still maintaining control), the momentum of the trailer will carry it over the lip.

view full answer...

Answer 3

To connect the reverse wire from the Tekonsha OEM Replacement Vehicle Wiring Harness #TK57VR to your 2022 Toyota Highlander you'll need to route it up the paneling at the back of your Highlander, through the boot that connects from your vehicle…

view full answer...

Answer 4

If you don't see any bolts holding the existing jack onto the trailer frame, it might have been installed by welding it in place. If this is the case, you'd need to grind off the welds, which is something you'd probably need a…

view full answer...

Answer 5

You wouldn't want to try and move a trailer up an incline with the MT70881. The dolly itself would be fine but you would most likely not be able to pull that heavy of a trailer up an incline. And then if you somehow did get it going up the…

view full answer...

Answer 6

Thank you for the photo, it was beneficial in determining that you will be fine using the Trailer Valet 5X Swivel Jack #STC-V211 with your V-Nose trailer. I called Trailer Valet, and they told me that the top crank was roughly 7 inches long. If you…

view full answer...

Answer 7

I will start by saying the ARK Extreme Off-Road Ratcheting Trailer Jack w/ Wheel #ORJW1SU will fit frames that are 2" to 6" tall. The bolt hole measurements vary and I included a diagram with everything listed, but the overall dimensions of…

view full answer...

Answer 8

I wasn't sure exactly what dimension you were looking for on the mounting bracket of the Trailer Valet part #STC-V211 so I attached a picture that has nearly every dimension for you to check out.

view full answer...

Can The Trailer Valet Be Purchased And Shipped To Florida?

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching