Which Axle of Tandem Axle Trailer Typically is the Brake Axle

Question

Question:

On a Tandem Axle Trailer with Brakes on Only One Axle, Is it better for the brakes to be on the Front Axle or the Rear Axle, or does it matter? The other axle has no brakes. It just free wheels.

asked by: Mike H

1

Helpful Expert Reply:

Really it depends on which axle is carrying more of the weight. Typically the front axle is the braking axle for most utility trailer and campers but for boat trailers where the weight is more on the back it's typically the rear axle.

We have also found that most torsion brake axles are the rear axles as well.

expert reply by: Jameson C

1

Answer 1

PVC Grommet #a70gb and the lights that fit with them have to have a tight fit in the trailer. Try to press them into the hole as evenly on both sides as possible. Using some soapy water on the grommet and trailer will help it to install easier. If…

view full answer...

Answer 2

A brake axle would have brakes, either electric or hydraulic drum or disc brakes while an idler hub would have no brakes. Many times, a tandem axle trailer will have one braking axle and one idler axle. The 3500 lb capacity #35545I-EZ-89 axle you…

view full answer...

Answer 3

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 4

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 7

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Which Axle of Tandem Axle Trailer Typically is the Brake Axle

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching