Accesories Needed to put a Hitch Bike Rack on a 2008 Toyota Camry SE with Draw Tite # 36416 Hitch
Question:
Considering the Draw Tight model 36416 for 2008 Camry to attach a bike rack to the 1 1/4 receiver. Do I need to order any other parts? Do not need lights or ball parts? Thanks,
asked by: Chip
Expert Reply:
There might be some products you may be interested in purchasing, but once you have this Draw-Tite Hitch Receiver, part # 36416 installed onto your 2008 Toyota Camry you would not need anything else to put a bike on the 1-1/4 inch receiver of the # 36416. I included the installation instructions and a video of the install being done on a similar Toyota Camry below.
You will not need lights because the lights from your Camry should still be visible, and the bike rack attaches to the hitch directly without the use of a draw bar, so ball or draw bar accessories would not be necessary to use a hitch mounted bike rack.
For a bike rack I recommend the Thule Camber, part # TH9058. I have included a video review of this bike rack for you to check out.
If you have a womens, or odd framed bike you might be interested in a Thule Bike Adapter Bar for Hitch Bike Racks, part # TH982XT. I have a link to video review of this product below.
You may be interested in a Thule Snug Tite Hitch Lock and Anti-Rattle Device, part # THSTL2 also. I included a review video below that you may find informative also.
Products Referenced in This Question
Thule Camber Bike Rack for 2 Bikes - 1-1/4" and 2" Hitches - Tilting
- Hitch Bike Racks
- Hanging Rack
- Folding Rack
- Tilt-Away Rack
- Frame Mount
- Locks Not Included
- 2 Bikes
- Class 1
- Class 2
- Class 3
- Fits 1-1/4 Inch Hitch
- Fits 2 Inch Hitch
- Fits 1-1/4 and 2 Inch Hitch
- Thule
more information >
Thule Bike Adapter Bar for Women's and Alternative Frame Bikes
- Accessories and Parts
- Hitch Bike Racks
- Spare Tire Bike Racks
- Trunk Bike Racks
- Adapter Bar
- Frame
- 16 - 31-1/2 Inch Long
- Thule
more information >
Thule Snug Tite Hitch Lock and Anti-Rattle Device
- Trailer Hitch Lock
- Rack Specific Locks
- Keyed Alike
- Fits 1-1/4 and 2 Inch Hitch
- Fits 1-1/4 Inch Hitch
- Fits 2 Inch Hitch
- Threaded Pin
- For Thule Racks
- Thule
more information >
Product Page this Question was Asked From
Draw-Tite Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4"
- Trailer Hitch
- Custom Fit Hitch
- Class II
- 300 lbs TW
- 3500 lbs GTW
- 1-1/4 Inch Hitch
- Concealed Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Recommended Hitch For A 2011 Toyota Camry LE V6 With Dual Exhaust
- Article: How to Choose the Right Trailer Hitch Class
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Availability of Replacement Thule Shut Tite Hitch Lock Housing
- Q&A: How to Determine Correct Hitch Extender for Bike Rack on Jeep Wrangler with Rear Spare Tire
- Article: How to Measure for Trailer Hitch Drop
- Q&A: What Area Needs to be Trimmed on a 2012 Honda CR-V to Install Trailer Hitch 75742
- Article: What Do I Need To Tow A Trailer?
- Q&A: Curt Trailer Hitch # C11576 Install Instructions
- Q&A: Trailer Hitch Recommendation for 2019 Toyota Camry Hybrid
- Q&A: What is the Purpose of M6 Screws for Thule Apex XT 4 Bike Rack
- Article: Trailer Tire Sizing
- Article: Best Bike Racks for Electric Bikes
- Article: How to Replace or Install an RV Roof Vent