Trailer Hitch Fit for 2002 Ford Ranger Flare-Side Bed Pickup
Question:
Hello I have a ford ranger 2002 with flared side truck bed. What rear hitch will fit my vehicle. Thank you so much. Regards.
asked by: Keith U
Expert Reply:
We offer both 1-1/4-inch Class II and 2-inch Class III hitches for your 2002 Ford Ranger with flare-side bed. I suggest the 2-inch hitch since it offers broader compatibility with hitch-mounted accessory items. All options are shown on the linked page.
Curt Class III hitch # 13019 is a square tube hitch confirmed to fit your truck, and so is the round tube hitch # 13138. Both offer the same capacity but some owner's will prefer the appearance of one style over the other. Drilling is required for all hitches and the written instructions are linked for you along with a helpful article.
Products Referenced in This Question
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 400 lbs TW
- 4000 lbs GTW
- 6000 lbs WD GTW
- 2 Inch Hitch
- 600 lbs WD TW
- Visible Cross Tube
- CURT
more information >
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 400 lbs TW
- 4000 lbs GTW
- 6000 lbs WD GTW
- 2 Inch Hitch
- 600 lbs WD TW
- Visible Cross Tube
- CURT
more information >
Product Page this Question was Asked From
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 400 lbs TW
- 4000 lbs GTW
- 6000 lbs WD GTW
- 2 Inch Hitch
- 750 lbs WD TW
- Concealed Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: What is Max Safe Tire Temperature
- Q&A: What Size Battery Is Needed for the Lippert 6-Point Ground Control
- Q&A: Could GO Power Solar Panel kit part # 34273836 Mount to Pin Box and Use SAE Port
- Q&A: Bolts and Bracket for the Tie Down Caliper to Kodiak Caliper
- Q&A: Recommended Replacement Hub Assemblies for a Trailex Trailer with a 8 inch Wheel with 4 Bolts
- Q&A: Can I Charge My Trailer Battery Using 7-Way Trailer Connector on Truck
- Q&A: Size of Hole Saw to Use to Install the Recessed Trailer D-Ring Tie Down RR5K
- Article: My Trailer Hitch Doesn't Fit
- Article: How to Measure for Trailer Hitch Drop
- Article: Which Hitches are Made in the USA
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Article: Trailer Wiring Diagrams