Installing The Draw-Tite Hitch # 75471 On A 2009 Hyundai Santa Fe
Question:
Do you install the 3/16 1.00x2.00 blocks on all 4 bolts or only on 3 bolts?
asked by: Joe J
0
Expert Reply:
When installing the Draw-Tite Class III 2 Inch Hitch # 75471 on your 2009 Hyundai Santa Fe you will install the 3/16 inch blocks on all four bolts. I am including a link to the installation instructions on the Draw-Tite hitch and a video link to the Draw-Tite hitch being installed on a 2009 Hyundai Santa Fe.
expert reply by:
Jeff D
0
Product Page this Question was Asked From
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 525 lbs TW
- 3500 lbs GTW
- 2 Inch Hitch
- Concealed Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: How Do I Tell if My Hyundai Santa Fe Has a Tow Package?
- Q&A: Hitch Fits and Towing Capacity of 2014 Hyundai Santa Fe
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: My Vehicle has a 4-Pin Trailer Plug, but Trailer has 7-Pin Trailer Plug
- Q&A: How to Add a 7-Way Trailer Connector to a 2014 Hyundai Santa Fe
- Q&A: Trailer Wiring for 2019 Hyundai Santa Fe Without Factory Tow Package
- Q&A: Can a 2016 Riverside Whitewater Retro 155XL Be Raised for More Ground Clearance
- Article: My Trailer Hitch Doesn't Fit
- Article: Brake Controller Installation: Starting from Scratch
- Article: How to Clean Weld Nuts for the Installation of a Trailer Hitch | etrailer.com
- Article: How to Choose the Right Trailer Hitch Class
- Article: Rooftop Cargo Carriers
- Article: Trailer Hitch Receiver Sizes