How Is Footplate For etrailer A-Frame Trailer Jack Removed
Question:
How do I remove it ?A frame trailer jack wit foot removal
asked by: Phifer
Helpful Expert Reply:
The etrailer A-Frame Jack, part # TJA-5000S-B has a mounting plate that can be welded or bolted to the trailer frame.
If you are asking about the foot plate like part # JF-99, the foot plate is attached to the jack by slipping the footplate over the tube on the jack and inserting the included bolt on the footplate through the footplate frame and the holes in the leg of the jack.
It is possible your jack may not be this model and has a footplate that cannot be removed.
Products Referenced in This Question
Footplate for 2,000-lb and 5,000-lb Round, A-Frame Jacks
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Jack Foot
- etrailer
more information >
Product Page this Question was Asked From
Round A-Frame Trailer Jack - Sidewind - 15-5/8" Travel - 5,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jacks
- Steel
- 4001 - 5000 lbs
- Sidewind Jack
- 16 Inch Lift
- Bolt-On
- Weld-On
- No Wheel or Foot
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: 2 inch Outer Diameter A-Frame Trailer Jack Recommendation
- Q&A: Alternative Ways to Power the Ultra-Fab Electric A-Frame Jack
- Q&A: Smaller Trailer Tire Than 215/75R14 w/ 5 on 4-1/2" Bolt Pattern To FIt in Garage
- Article: Trailer Maintenance Schedule
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: How to Measure for Trailer Hitch Drop
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Q&A: Mounting Tab and Hole Size and Spacing of Ultra-Fab # UF48-979006 Scissor Jack
- Q&A: How to Find Connector for Back Up Sensors When Installing 118760 Trailer Wiring on 2019 Honda Pilot
- Q&A: Wiring 3-Wire Breakaway Switch as Replacement for 2-Wire Switch
- Q&A: Correct Grease Seal for a Boat Trailer that 10-19 Seal won't Fit