Fifth Wheel Hitch Recommendation and Rail Kit for 2013 Ford F-350
Question:
I recently purchased a 2013 F350. The previous owner had a fifth wheel hitch in it but was removed before I purchased it. I do not know whos hitch it was. My question is will any manufacturers hitch fit the holes that have been drilled or do I need to try to figure out what was previously in it?
asked by: Terry C
Expert Reply:
Sounds like the previous owner removed the hitch and the base rails that you would see installed in the bed of the truck. If you did happen to still have the rails though and they are 22 inches apart on center (the standard rails design) then the Reese 16k hitch part # RP30047 would fit them and work well.
Otherwise you would want a rail kit # RP56016-53 as well to give your truck bed a set of rails for the hitch to install into. This is a custom install kit that installs in half the time and minimizes drilling.
Products Referenced in This Question
Reese Quick-Install Custom Outboard Installation Kit w/ Base Rails for 5th Wheel Trailer Hitches
- Fifth Wheel Installation Kit
- Custom
- Above the Bed
- Reese
more information >
Product Page this Question was Asked From
Reese 5th Wheel Trailer Hitch - Dual Jaw - 16,000 lbs
- Fifth Wheel Hitch
- Fixed Fifth Wheel
- Aftermarket Below Bed Rails
- 4000 lbs Vertical Load
- 16000 lbs GTW
- Double Pivot
- Standard - Double Jaw
- 13-1/2 - 17 Inch Tall
- Reese
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Sidewinder with Rotating Turret for Short Bed Pickups
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Q&A: Can I Use A Curt A20 With A Reese Sidewinder On A Ram Truck With The Rambox
- Article: Ram Trailer Tow Prep Package
- Q&A: Does Truck with 6-1/2 ft bed Have to Use Slider Hitch for Turning Clearance with Fifth Wheel Hitch
- Article: 5th Wheel Hitch Installation | The Ultimate DIY Guide
- Article: Gooseneck to 5th Wheel Adapters
- Q&A: Wedge For Reese Sidewinder RP34FR & Demco Recon 5th Wheel Hitch
- Q&A: What Is An OEM Prep Package And How Do I Know If I Have It
- Article: Fifth Wheel Hitch Combinations for Ram Trucks with RamBox (2009-Current)
- Q&A: Are Capture Plates Needed When Using the Demco Autoslide With a Lippert Road Armor Pin Box
- Q&A: Can I Use a Turning Point Wedge w/ a B&W Companion Hitch and a Reese Sidewinder?
- Q&A: How Much Do the Components for the B&W Companion 5th Wheel Hitch for Chevy/GMC Puck System Weigh?