What Size Mounting Bolt Should be Used for Pollack Mounting Bracket # PK11771?
Question:
item: PK11771, the drawing dimensions look 2.25 inch center of the slot. will it accommodate 2.5 inch center 1/4inch bolts?
asked by: Sid
0
Expert Reply:
The diameter of the top mounting hole on # PK11771 is 5/8 inches long by 5/16 inches wide. This means that a 1/4 inch bolt would work great to attach this mounting bracket like the self tapping # FA1131822.
I have linked the above mentioned products to this page for your convenience.
expert reply by:
Jackie C
0
Products Referenced in This Question
Self-Tapping Screw - 1/4" -14 x 3/4" Long - Zinc
- Accessories and Parts
- Trailer Wiring
- Wiring
- Ground Screw
- Flint Hill Goods
more information >
Product Page this Question was Asked From
Pollak Bracket for Single-Pole Trailer Wiring Socket
- Accessories and Parts
- Trailer Wiring
- Mounting Hardware
- Brackets
- 1 Round
- Pollak
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Key Position for Flat Towing a 2014 Jeep Wrangler Sahara
- Q&A: Where to Install Safety Cables on Jeep Off Road Bumper When Using D-Ring Adapters
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: When Flat Towing a Vehicle How Much Tongue Weight is on the Trailer Hitch
- Q&A: Recommended Replacement for Atwood Surge Brake Actuator 85778
- Q&A: Does Jeep Wrangler Battery Need Charging When Using Curt Tow Bar Wiring
- Q&A: How to Replace Interior Ram Jack Rod and Nut # TJD-12000-RODNUT on 12000 Series Jacks
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Flat Towing Package for 2014-2018 Jeep Grand Cherokee
- Q&A: Tow Bar Wiring Kit Recommendation for 2021 Ford Ranger
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Must-Have Flat Towing Components
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)