Can the Bulb in Light, Red Flush Mounted Sealed Turn Signal - Oval, # ST70RB, Be Replaced
Question:
Is it possible to change the bulbs in these lights or do you replace the whole sealed unit?
asked by: Keith
Expert Reply:
The Light, Red Flush Mounted Sealed Turn Signal - Oval, # ST70RB, is a sealed light and is not meant to be opened to replace the bulb inside. I went out to the warehouse and pulled one of these lights to double check and it is sealed. I then checked other lights with the same dimensions and they are all sealed as well.
I would recommend going with an LED light since LEDs last longer than incandescent bulbs and draw less power. Take a look at the Sealed, 6-1/2 inch Oval LED Trailer Stop, Turn and Tail Light, 48 Diode, # STL70RB. The grommet for this light is # a70gb and the wiring harness is # A45PB.
Products Referenced in This Question
3-Wire Pigtail for Optronics Trailer Lights - 3-Prong PL-3 Plug - 10" Lead
- Accessories and Parts
- Trailer Lights
- Wiring
- Plugs and Pigtails
- 10 Inch Long
- Three Wire
- Straight Pigtail
- Optronics
more information >
PVC Grommet for 6-1/2" Oval Trailer Tail Lights
- Accessories and Parts
- Trailer Lights
- Mounting Hardware
- Grommet
- 6-1/2 Inch Long
- Oval
- Optronics
more information >
Optronics LED Trailer Tail Light - Stop, Tail, Turn - Submersible - 48 Diodes - Oval - Red Lens
- Trailer Lights
- Tail Lights
- Stop/Turn/Tail
- Oval
- Recessed Mount
- Submersible Lights
- LED Light
- 6-1/2L x 2W Inch
- Red
- Optronics
more information >
Product Page this Question was Asked From
Optronics Trailer Tail Light - Stop, Turn, Tail - Submersible - Incandescent - Oval - Red Lens
- Trailer Lights
- Tail Lights
- Stop/Turn/Tail
- Oval
- Recessed Mount
- Submersible Lights
- Incandescent Light
- 6-1/2L x 2-1/4W Inch
- Red
- Optronics
more information >
Continue Researching
- Q&A: How Much Slack Is Needed In Trailer Wire Connection To The Tow Vehicle?
- Q&A: Torque Specs for 3500-lb 5-on-4-1/2 Dexter Hub/Drum 84546UC3
- Article: Harvest Hosts
- Q&A: Repair Kit Fulton Wedge-Latch # F670801, Fits Fulton/Bulldog Couplers for 2-5/16 Inch Balls
- Q&A: Does Furrion Single Zone Controller part # FACC12SA-BL Have Dip Switches
- Q&A: Where Is the Brake Controller Plug On a 2021 Ford F-150
- Q&A: Replacement Trailer Hub/Drum for Part Number 2420801
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Replacement For TDE LP75 Disc Brake Actuator
- Article: Trailer Wiring Diagrams
- Article: Trailer Lighting Requirements
- Article: Trailer Maintenance Schedule
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Measure for Trailer Hitch Drop