Options for Wiring in 7-Way to 2004 Chevy Silverado
Question:
I hooked up a 7 wire connector for my camper. I tapped into the tail light wires and I do not have any brake lights on my camper when I hit the brakes. Is there any other wires to use for this problem?
asked by: Jim
Expert Reply:
Sounds like you wired in a 7-way to your 2004 Chevy Silverado. There should have been a socket there near the rear bumper that would allow a 7-way like the part # HM40975 to install without requiring you to splice anything.
Your truck has separate taillights from the turn signals so it sounds like you wired the stop/turn circuit of the 7-way to just the turn signals of your truck. If you wanted to convert the signal of your truck to combined you would need to wire in the part # RM-732 to the taillight circuits between them and the 7-way.
Products Referenced in This Question
7- and 4-Pole Trailer Connector Socket w/ Mounting Bracket - Vehicle End
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- No Converter
- Custom Fit
- 7 Round - Blade
- 4 Flat
- Hopkins
more information >
Roadmaster Brite-Lite Wiring Converter
- Tow Bar Wiring
- Splices into Vehicle Wiring
- Tail Light Converter
- Universal
- Roadmaster
more information >
Product Page this Question was Asked From
Pollak Metal 7-Pole, RV-Style Trailer Socket - Vehicle End
- Trailer Wiring
- Trailer Connectors
- Vehicle End Connector
- Plug Only
- 7 Round - Blade
- Pollak
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Do 8k Oil Bath End Caps On Lippert Axle Interchange With Dexter End Caps
- Q&A: Recommended Electric Over Hydraulic Brake Set Up for 2016 Montana 3710FL 5th Wheel
- Q&A: Replacement Grease Seals For TRP GS-1719DL
- Q&A: Is Adapter Needed to Install Dometic Water Heater # DMC74FR In Place of Atwood
- Article: Brake Controller Installation: Starting from Scratch
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Printable Trailer Bolt Hole Pattern Template
- Q&A: Recommendation for Installation of a Brake Mounting Flange on a Trailer Spindle and Axle
- Q&A: Do I Need Brakes On Both Axles of a Car Hauler Trailer?
- Q&A: Leaf Spring Recommendation for 4,400 lb Trailer Axle
- Article: How to Replace Trailer Leaf Springs in 5 Steps
- Article: Hitch Adapters and Extenders
- Article: Troubleshooting Brake Controller Installations