How Would a Back Up Camera be Wired So That it is On all the Time
Question:
Looking for a rear view camera for my Aliner Expedition. Not a back up camera, but one that can be used while driving down the road to see whats behind.
asked by: Charlene
1
Helpful Expert Reply:
In order to wire a backup camera to be on all of the time, you would have to wire it into the running light circuit instead of the reverse light circuit. This way, when you wanted it on, you would just turn the running lights on. This would be the easiest way to turn it off and on.
For a camera the Hopkins part # HM60195VA would be a great choice.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Hopkins Rear View Camera with Backup Sensors - 2-1/2" LCD
- Backup Camera
- Backup Camera Systems
- License Plate Camera System
- Hardwired
- Windshield Monitor
- 2.5 Inch Display
- Hopkins
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Will Air Bag Suspension Enhancement Make Unloaded Truck Ride Quality Smoother
- Q&A: What Size Wire Gauge is Used in Vision X 9007 Halogen Headlight Bulbs with Relay Harness
- Q&A: Replacing 2013 Toyota Tundra Factory Tailgate Mount Backup Camera to Allow Camper Installation
- Article: Performance Chips and Modules
- Article: Gooseneck to 5th Wheel Adapters
- Q&A: Can The Dometic Portable Toilet Be Dumped At Campground Septic Dump Area
- Q&A: Does Dometic Portable Camping Toilet Contain Smells
- Article: Trailer Maintenance Schedule
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Will the VueSMART RV and Trailer Backup Camera Work In Place of a License Plate Light
- Q&A: Can Second Camera Source be Used for Custom Third Brake Light Camera System w/ Rear View Mirror
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Car Camping Checklist