Replacement Trailer Hub that Uses Bearings with Inner Diameters of 1.25 and 0.75 Inches
Question:
I have a small trailer that needs both hubs. The original hubs were lost during a house fire. The spindle outer bearing surface is .75, the inner bearing surface is 1.25, the seal surface is 1.625. Are these measurements enough to determine what hub will fit?
asked by: Jimmy
Expert Reply:
Based on the measurements you have provided hub # AH15450ECOMP is a close match. The bearings that it uses fit on spindles with the measurements you have provided. But the seal has an inner diameter of 1-1/2 inches. It is not uncommon for the seal inner diameter to be smaller to provide a tight fit.
This is an agricultural hub so it isn't very common and being an aggie hub means it is limited to 20 miles per hour.
It might be more beneficial to replace the axle on the trailer to get more common hubs that will have readily available replacement parts. We have some axles, see link, but if not match what you need then you could order one from a local trailer supply store.
Products Referenced in This Question
Trailer Hub Assembly - 3,000 lbs Axles - 4 on 5 - Agricultural
- Trailer Hubs and Drums
- Hub
- Agricultural
- LM67048
- LM11949
- For 3000 lbs Axles
- 1/2 Inch Stud
- 4 on 5 Inch
- TruRyde
more information >
Product Page this Question was Asked From
Square #84 Spindle for 3,500-lb Trailer Axles - 1-1/2" Wide
- Trailer Spindles
- Standard Spindle
- 1-1/2 Inch Diameter
- Square
- For 3500 lb Axle
- TruRyde
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Easy Grease Trailer Idler Hub Assembly for 2K Axles - 13" to 15" - 5 on 4-1/2 - PreGreased
- Search Results: 1.25 spindle
- Q&A: Recommended Replacement Grease Seal for 2014 Shorelander Boat Trailer
- Article: How to Charge a Dump Trailer Battery
- Q&A: Recommended Lithium Battery Compatible Power Converter For Parallax 7355
- Q&A: Does Correct Track Trailer Alignment Kit # RR23QX Come with Enough Brackets for Tandem Trailer
- Q&A: How Does the Correct Track Trailer Alignment and Lift Kit Really Work
- Q&A: Is There Down Side to Progressive Dynamics 4000 Series 60 Amp Over 45 Amp
- Q&A: Is the Progressive Dynamics Lithium Converter PD4655LIV An Upgrade for the Parallax 7355
- Q&A: Recommended Replacement For A WFCO WF-8750P Power Center
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Trailer Hitch Receiver Sizes
- Article: Roadmaster Vehicle Specific Base Plates
- Article: Trailer Maintenance Schedule
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Most Popular Wheel Bearings