The Curt 2 Inch Class III Hitch, # 13707, On A 1999 Ford Crown Victoria Seems Too Low To The Ground
Question:
I purchased this part (13707) for my 1999 Crown Victoria and the receiver seems to low to the ground. In fact, the hitch is some 9 inches from the ground on an empty gas tank. Do you have any suggestions on this? Is this simply a problem with this car?
asked by: Clark C
Expert Reply:
The Curt 2 Inch Class III Hitch, # 13707, is the correct hitch for your 1999 Ford Crown Victoria. It should measure 10-7/8 inches from the ground to the top of the receiver opening. If you are measuring to the bottom of the hitch it will be about 8-7/8 inches since it is a 2 inch hitch. This is not a problem with that vehicle.
If towing, you do need to use the recommended ball mount which is Draw-Tite Mount, # 2753. This ball mount when used in the 2-3/4 inch rise position will put the hitch ball at 13-5/8 inches from the ground. That should work for towing a trailer with your vehicle.
If the trailer coupler height is much higher than the 13-5/8 inch measurement that would mean that the trailer should not be towed with your vehicle.
I am sending a link to information on measuring hitch height and coupler height.
Products Referenced in This Question
Draw-Tite Ball Mount for 2" Hitches - 2-3/4" Rise, 4" Drop - 9" Long - 7.5K
- Trailer Hitch Ball Mount
- Fixed Ball Mount
- No Ball
- 1 Inch Ball Hole Diameter
- Steel Shank - Gloss Black
- Drop - 4 Inch
- Rise - 3 Inch
- Fits 2 Inch Hitch
- 7500 lbs GTW
- Class III
- Draw-Tite
more information >
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 400 lbs TW
- 4000 lbs GTW
- 6000 lbs WD GTW
- 2 Inch Hitch
- 600 lbs WD TW
- Concealed Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Shop: Trailer Hitch
- Article: How to Choose the Right Trailer Hitch Class
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Parts Needed To Install a Trailer Brake Controller On a 2024 Hyundai Santa Cruz With Factory 7-Way
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Which Wiring Harness Fits 2024 Hyundai Santa Cruz With Tow Package
- Q&A: Parts Needed to Add Brake Controller to 2024 Hyundai Santa Cruz With Tow Package
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Trailer Wiring Harness Recommendation for a 1998 Ford Crown Victoria
- Q&A: Spare Tire & Wheel For 2023 Coleman Lantern 17B
- Q&A: Replacement Grease Seal 225255UC for 2015 Wesco Trailer
- Q&A: Comparing Etrailer Hitch vs Curt Trailer Hitch for 2015 Subaru Forester
- Article: Performance Chips and Modules
- Article: Trailer Wiring Diagrams