Troubleshooting Trailer Stop/Turn Signals Not Functioning When Running Lights Still Work
Question:
Hi I am running a 6 by 10 utility trailer from an F250 pickup truck 2005 and both turn signals and brake lights stopped working but all the running lights are working what could be my issue
asked by: Jim
Expert Reply:
Since they both stopped working at the same time and the circuits you mentioned draw more amperage than the running light circuits the issue sounds like a bad ground for the trailer lights.
Make sure that the trailer and vehicle side connector are clean and free of corrosion inside and out. The main connector grounds should be attached to clean and corrosion free bare metal surfaces. The light grounds should also be attached to clean and corrosion free bare metal surfaces. If there is anything between a light ground and the metal trailer frame or if the trailer has an aluminum frame, tilt bed, or folding tongue, any of these things can interrupt the ground. Running jumper wires from the light grounds to the main trailer connector ground can help.
Product Page this Question was Asked From
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Parts Needed For Flat Towing a 2024 Ford Maverick Behind a 2010 Winnebago Journey With Air Brakes
- Q&A: Caliper Bolts for AL-KO/Hayes Disc Brake Caliper BP18-050
- Q&A: Replacement Oil Seal for AL-KO 568303
- Q&A: Does The Progressive Dynamics PD4655V Have A Lithium Jumper
- Q&A: Which Instructions Are Used Installing a Roadmaster Brake-Lite Relay in a Ford F-150 w/ Neutral Tow
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Recommended Diode for Charging Line From Motorhome to Towed Vehicle (Toad)
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Maintenance Schedule
- Q&A: What Gauge Wire does 4-Way Trailer Wiring Use
- Article: Trailer Tire Sizing
- Article: Flat Towing Package for 2014-2015 Chevrolet Equinox