Replacement Key for Older Sears X-Cargo 2802

Question

Question:

I have lost the keys for an old Sears X-Cargo car-top carrier. The carrier is white/gray, and the locks on it have the code 2802inch etched into the lock. Will part # THKEYN2802 work on this old carrier?

asked by: James K

0

Expert Reply:

Yes, for your Sears X-Cargo box with a lock core that has 2802 the correct key is the part # THKEYN2802.

expert reply by: Jameson C

0

Answer 1

This key may work with your Sears X-Cargo Sport 20 Cargo Box, but the lock on the cargo box must have same key number stamped on the face of the lock (see photo). The X-Cargo Sport 20 was made by Thule and Thule used their locking system with these…

view full answer...

Answer 2

For your old Sears X cargo roof box, I recommend the Replacement Hardware Kit for Searsbox Cargo Box #TH05603 which is a confirmed fit for the Sears X-Cargo sport 20 Carrier. This will fit holes 4 inches on center. If you have different measurements…

view full answer...

Answer 3

According to SportRack, the #TH02943 U-Bolt is the correct replacement for your Aero XL cargo box.

view full answer...

Answer 4

The U-bolt you are asking about, the Replacement Part for the Thule Sidekick #TH02943 is 4" wide and 2" deep with a threaded portion of about 1-1/2". If you find it too short for your crossbars, you do have different options: First,…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 8

I have a solution for you, but we do not carry Glo-Brite lights, so replacing it with the same brand will not be something I can offer you. Instead, to replace your Glo-Brite 9852-88, I recommend using the Optronics LED Trailer Tail Light #STL72RB.…

view full answer...

Answer 9

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 10

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 11

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Answer 12

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Replacement Key for Older Sears X-Cargo 2802

Product Page this Question was Asked From

Continue Researching