Part Needed to Secure Wobble Roller to 5/8 inch Shaft
Question:
I need to replace my wobble rollers on my trailer. Currently they are attached with 8x5/8inch bolts and nuts. I want to refit and in looking for replacement parts I dont see a retainer ring for a 5/8inch bar. Any recommendations?
asked by: Brian
0
Expert Reply:
For a pal nut designed to fit a 5/8 inch shaft you would want the part # CE10801 which will secure to the end of a 5/8 inch shaft.
We don't have a retainer ring for that shaft size.
expert reply by:
Jameson C
0
Products Referenced in This Question
Replacement Cap Nut - Zinc - 5/8" - Qty. 1
- Accessories and Parts
- Boat Trailer Parts
- Hardware
- 5/8 Inch Diameter
- Nuts
- Cap Nut
- CE Smith
more information >
Product Page this Question was Asked From
CE Smith Wobble Roller Retainer Ring - Zinc-Plated Steel - Qty 1
- Accessories and Parts
- Boat Trailer Parts
- Hardware
- Retaining Ring
- CE Smith
more information >
Continue Researching
- Article: Most Popular Wheel Bearings
- Q&A: Replacement Wobble Roller Needed with 1 Shaft for Older Boat Trailer
- Q&A: Troubleshooting A Bouncy Ride On A Vanleigh RV Vilano 325RL Fifth Wheel Trailer
- Q&A: Recommended Replacement Wobble Roller Parts for Venture Boat Trailer
- Q&A: How to Install Wobble Rollers on Older Boat Trailer
- Q&A: Comparing Gen-Y 5TH Wheel To Gooseneck With 1621 Pin Box Lengths
- Q&A: Replacement Wheel Cylinder for EZ Loader Boat Trailer
- Q&A: Comparing Replacement Endcap for Fulton Bolt-Thru Swivel Marine Jacks F500323 and 500323
- Article: Trailer Wiring Diagrams
- Article: Sidewinder with Rotating Turret for Short Bed Pickups
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Trailer Tire Sizing
- Article: How to Choose the Best Winch for You, your Boat, and your Trailer
- Article: How to Measure for Trailer Hitch Drop