Diameter Dimension of Locking Pad Lock Hole on # UF21-001080 Wheel Chock
Question:
I have a lock that I would rather use on this locking chock. What is the diameter of the hole that the lock shackle fits through?
asked by: JonF
0
Expert Reply:
I was able to go out to the warehouse and measure the inner diameter of the lock hole on the Ultra-Fab Wheel Chock # UF21-001080 for you.
I found that with a digital caliper the inner diameter was .36 which is about 23/64 of an inch and just under 3/8 of an inch.
I have linked the above mentioned part to this page for your convenience.
expert reply by:
Jackie C
0
Product Page this Question was Asked From
Ultra-Fab Chock and Lock Wheel Stabilizer for Tandem-Axle Trailers and RVs - Up to 10" Wide
- Wheel Chocks
- Wheel Chock
- Wheel Stabilizer
- RV
- Trailer
- Steel
- Single Chock
- Silver
- Ultra-Fab Products
more information >
Continue Researching
- Q&A: Parts Needed To Activate Trailer Brakes With A 2024 Toyota Grand Highlander
- Article: Pintle-Hitches
- Q&A: Could Redline 2-Way Pop-Up Roof Vent # 9106-2756 Install in Ford Transit Connect Van
- Q&A: 20 Amp Charge Controller Compatible With Goal Zero Boulder 200 Briefcase
- Q&A: Does Ultra-Fab Products Wheel Chocks # UF21-001080 Fit Wheel Spacing of 7 inch
- Q&A: What is the Difference Between the Coil SumoSprings Parts # CSS-1168 and # CSS-1168R
- Q&A: Troubleshooting Left Front Jack Error Code on Lippert Ground Control Leveling System
- Q&A: Troubleshooting Lippert Ground Control 3.0 That Works But Rear Lights Flash While Operating
- Article: Trailer Maintenance Schedule
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: Best Bike Racks for Electric Bikes
- Article: Stability Control for Heavy Duty Vehicles
- Article: 5 Things to Know About Weight Distribution Hitches