Why Do I Not Have Power to My Tail Light in My 2012 Nissan Frontier using # C56225
Question:
The C56225 harness was installed in 2012 and worked fine until a couple of weeks ago. Now I have no power to the tail light circuit. I do have power to left and right turn signal circuits. Need some help.
asked by: Mike M
Helpful Expert Reply:
It sounds like the relay for the taillights went bad. To replace the relays you can use part # C57000 to swap out all three. This will fix your issue and allow your taillights to work again. You can find all three relays with the wiring harness behind the passenger kick panel.
Products Referenced in This Question
Curt Relay Kit for Nissan Armada or Titan Aftermarket Tow Package
- Accessories and Parts
- Trailer Wiring
- Relays
- CURT
more information >
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- No Converter
- Custom Fit
- 4 Flat
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: How to Tell If MORryde Rubber Equalizers Will Fit Trailer
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Must Have RV Accessories that Will Make or Break Your Trip
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Is Bow in 3,500 lb Trailer Axle Enough Camber for Loaded and Unloaded Trailers
- Q&A: Are Relays Required to Activate the Trailer Wiring Harness on a Nissan Frontier
- Q&A: Correct Replacement for AL-KO 7230 Hub/Drum and Brakes
- Article: Trailer Wiring Diagrams
- Q&A: How to Replace a 4-Way Trailer Connector with 8 Wires
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Replacement Brake Shoes for Dexter 12k Axles
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: Nissan Tow Package Wiring Harness 118266/118267 - 7 Way Harness Installed and Electric Brakes Locked
- Article: Trailer Hitch Installation Tips