Picture of Pro Series Jack PS1400300303 Installed on a Trailer
Question:
Picked up jack ps1400300303 wanted to see if I mounted it right goes on a5/8foot tilt . Seems mounting plate is not cover much surface
asked by: Doug M
0
Expert Reply:
It looks like the Pro Series Jack part # PS1400300303 you referenced is installed correctly!
expert reply by:
Jameson C
0
click to enlarge
click to enlarge
Product Page this Question was Asked From
Pro Series Round, Snap-Ring Swivel Jack - Bolt On - Topwind - 10" Lift - 2,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 1001 - 2000 lbs
- Topwind Jack
- 10 Inch Lift
- Bolt-On
- With Rectangle Foot
- Pro Series
more information >
Continue Researching
- Q&A: Does the Tekonsha P3 Trailer Brake Controller Turn Off or Stay On All the Time
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: Does etrailer Bolt-On Swivel Mounting Plate Fit Jack TJP-5001S-B
- Q&A: Load Range D ST205/75R14 Trailer Tire With Galvanized Steel Wheel & 5 on 4-1/2 Bolt Pattern
- Q&A: Looking for a Bolt-On Jack That is Less Than 11 Inches When Attached
- Q&A: Will the Pro Series Round Snap-Ring Swivel Jack Bolt on a 2 Inch Trailer Tongue
- Q&A: Replacement Dutton-Lainson Trailer Jack 22457 or 22560
- Q&A: Is Mounting Hardware Included with Pro Series 2K Swivel Trailer Jack
- Article: Best RV Roof Vents
- Article: Most Popular Wheel Bearings
- Article: Trailer Jacks
- Article: How to Measure a Trailer Axle
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Bleed Your Trailer Surge Brakes