bing tracking image
Q & A Icon

Do The Rear Jacks of the Lippert Ground Control Leveling System Mount to Inside or Outside of Frame  

Question:

Do the rear jacks mount on the outside of the frame or the inside. I havent looked yet but the proximity to my bathroom gray water and blackwater tanks may be an issue. It would also be very close to the center of the underslung spare tire. Also, wouldnt it be easier to just cut access where you need it and reseal with a good waterproof tape. I think a good flat plumber snake would be able to fish the wire harnesses to the front where the underbelly pan is easier to lower. 2013 Montana Mountaineer 375FLF.

0

Expert Reply:

The rear legs of the Lippert Ground Control 3.0 # LC358590 that you referenced mount to the outside of the trailer frame. I attached a picture that shows a typical install of the rear jacks.

In most cases no modification is needed to mount the rear jacks. I would doubt that you would have to cut up the body of your trailer to get the rear jacks attached.

expert reply by:
0
Jameson C
click to enlarge

Product Page this Question was Asked From


Q & A Icon

Continue Researching

See More Q&A Expert Answers >>