New 4-Way Trailer Connector has 4 Wires But Old 4-Way had 5 Wires
Question:
This old trailer I bought has five wires coming off the connector was broken. They are green, brown, yellow, brown, and white for the ground. My new 4 flat connector has only four wires. How do I connect? Thanks
asked by: Derek
0
Expert Reply:
Your old connector was what is called a wishbone harness such as # A35W42B. It had 2 wires that went to the running light pin. The running light pin is the one next to the ground pin. Attach both running light wires to the brown wire on the new 4-Way. White is ground, green is right turn signal/brake lights, and yellow is left turn/brake lights.
expert reply by:
Michael H
0
Products Referenced in This Question
35 Ft 4-Way Trailer Wiring Harness - Wishbone Style - 42" Ground
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- 31 Feet and Longer
- Plug and Lead
- 4 Flat
- Optronics
more information >
Product Page this Question was Asked From
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- 0 - 5 Feet Long
- Plug and Lead
- 4 Flat
- Draw-Tite
more information >
Continue Researching
- Q&A: Does The Draw-Tite trailer Hitch Receiver Come With One Or Two Hitch Pin Holes
- Q&A: Replacement Hub and Drum Assemblies for AL/KO 8460 Hubs and Drums
- Q&A: Replacement Zerk Fitting Recommendation for Dexter EZ Lube Spindle
- Article: Trailer Wiring Diagrams
- Q&A: Can 12 Volt Accessory Circuit of Trailer Wiring Keep 10 Amp Breakaway Battery Topped Off
- Q&A: Recommended Roof Rack Crossbars for Lance Cab Over Camper With Factory Tracks
- Q&A: Can You Install a 5th Wheel Hitch On a 2021 GMC Sierra 2500
- Q&A: 4-Way Trailer Connector that has 5 Wires
- Article: How to Measure for Trailer Hitch Drop
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Trailer Tire Sizing
- Article: Brake Controller Installation: Starting from Scratch
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Troubleshooting 4 and 5-Way Wiring Installations