Can the Ultra-Fab Hitch Mounted Skid Wheels # UF48-979015 Attach to 4 by 4 inch Hitch Tube
Question:
Thank you for providing the measurements. Is there any problem when you go to bolt the plates/wheels onto the 4inch x 4inch hitch tubing? It just seems like the distance between the plates holes doesnt allow for adequate room for the bolts without some or a lot of rubbing against the metal tubing. Im hoping this isnt the case as I would like to get the bolt-on over the weld-on, but definitely would be good to know before ordering.
asked by: Ryan
Expert Reply:
The Ultra-Fab Hitch Mounted Skid Wheels # UF48-979015 that you referenced would work well when attached to a 2-1/2" or 3-1/2" square hitch bar. There would be no interference at all.
I attached a review video for you to check out as well.
Product Page this Question was Asked From
Ultra-Fab Hitch Mounted Skid Wheels for RVs up to 30' Long - 4" Diameter - Qty 2
- RV Skid Wheels
- Hitch Mount
- 4 Inch Diameter Wheel
- Bolt-On
- Ultra-Fab Products
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: How to Tell if Dexter Axle 3,500 lb Electric Trailer Brakes Will Fit Axle
- Article: Trailer Tire Sizing
- Q&A: Parts Needed to Add Brakes to 2019 Meher Trailer with 3,500 lb Brakes
- Q&A: Skid Wheel Recommendation for a Camper Bumper that is 4 inch by 4 inch
- Article: Trailer Wiring Diagrams
- Q&A: Ultra-Fab Hitch Mounted Skid Wheels Height Dimension
- Q&A: How to Prevent the Trailer Hitch from Scraping the Ground on a 2015 Subaru Legacy
- Article: How to Raise Your Travel Trailer Height
- Q&A: How To Flip Square Trailer Axle For Ground Clearance
- Q&A: Recommendation for Preventing Car Trailer From Dragging Up Steep Driveway
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Determining Trailer Tongue Weight